Table of Contents
Advertisement
Memory Seat — If Equipped
If your vehicle is equipped with memory seat, your
remote keyless entry transmitter or memory seat
buttons on the driver's door panel can be used to
recall the driver's seat, outside mirrors and radio
station presets to saved positions.
The memory seat buttons located on the driver's
door will always recall stored settings. The remote
keyless entry transmitter can be programmed to
recall positions when the UNLOCK button is
pressed. See the following procedure on how to
link a remote keyless entry transmitter to a posi-
tion.
NOTE:
The vehicle must be in Park to recall memory
positions. If a recall is attempted when the
vehicle is not in Park, a message will be dis-
played in the overhead console.
To recall memory positions press memory button
number "1" if you are recalling the memory posi-
tion for driver one or press memory button number
"2" if you are recalling the memory position for
driver two. A recall can be cancelled by pressing
any of the memory buttons during a recall. When
a recall is cancelled, the seat stops moving and a
delay of approximately one second will occur
before any other recalls can be selected.
Your vehicle may have been delivered with two
remote keyless entry transmitters. One or both
transmitters can be linked to either memory posi-
tion. Up to four remote keyless entry transmitters
can be used with your vehicle. The memory seat
system can also accommodate up to four trans-
mitters linked to either of the two stored seat
positions or any combination of the two positions.
To Program Memory Seat Buttons, Follow
These Steps:
1. Turn the ignition switch to the ON position.
2. Use the seat and mirror switches to adjust the
seat, recliner and side view mirrors to the desired
positions.
3. Set the radio station presets (up to 10 AM and
10 FM stations can be set).
4. Press and release the SET "S" button located
on the driver's door. A chime will sound telling you
that you are in the set memory mode. You have
five seconds after the chime to complete the next
step.
5. Within 5 seconds, press and release button "1"
or "2" on the driver's door. A chime will sound
signaling you that the driver memory has been
set.
6. Within 5 seconds, press and release the LOCK
button on one of the Remote Keyless Entry Trans-
mitters. A chime will sound signaling you that the
transmitter has been successfully linked.
Repeat the above steps for the second position
using the other driver's door numbered button
and Remote Keyless Entry Transmitter.
Each time the SET "S" button and a numbered
button are pressed, you erase the old memory
and store a new one.
47
Advertisement
Chapters
Table of Contents
