Door Locks; Manual Door Locks; Power Door Locks - Chrysler Voyager 2001 Operating Information Manual

Table of Contents

Advertisement

DOOR LOCKS

Manual Door Locks

Lock the doors by pushing down on the lock
plungers on each door trim panel.
If the lock plunger is down when you shut the door,
the door will lock. Therefore, make sure the keys
are not inside the vehicle before closing the door.
WARNING!
For personal security and safety in the event of
an accident, lock the vehicle doors as you drive
as well as when you park and leave the vehicle.
14

Power Door Locks

A door lock switch is on each front door trim
panel. Use this switch to lock or unlock the doors.
If you press the power door lock switch while the
key is in the ignition, and any front door is open,
the power locks will not operate. This prevents you
from accidentally locking your keys in the vehicle.
Removing the key or closing the door will allow the
locks to operate. A chime will sound if the key is in
the ignition and the driver's door is open, as a
reminder to remove the key.
If you press the power door lock switch while the
sliding door is open, the sliding door will lock.
Auto Door Locks — If Equipped
The doors will lock automatically on vehicles with
power door locks if:
1. The transaxle is in gear,
2. all doors are closed
3. the vehicle speed is above 15 mph (24 km/h)
and
4. the doors were not previously locked using the
power door lock switch or remote keyless entry
transmitter.
The Auto Door Locks can be enabled or disabled
by performing the following procedure:
1. Close all doors and place the key in the ignition
switch.
2. Cycle the ignition switch ON/OFF four times
ending in the OFF position. (do not start the
engine)
3. Within 10 seconds of the final cycle, press the
interior driver's door lock switch to the LOCK
position.
4. A single chime will sound to signify that you
have successfully completed the programming.

Advertisement

Table of Contents
loading

Table of Contents