To Lock The Doors And Liftgate - Chrysler Voyager 2001 Operating Information Manual

NOTE:
You may turn off this feature and unlock all
doors with one press of the UNLOCK button by
using the following the procedure.
1. Press the UNLOCK button for 5 to 10 seconds.
2. While the UNLOCK button is pressed, (after 5
seconds) press the LOCK button. Release both
buttons.
The "Two Press" unlock feature can be reactivated
by repeating this procedure.

To lock the doors and liftgate:

Press and release the LOCK button on the trans-
mitter to lock all doors and liftgate.
To Open/Close Power Liftgate — If Equipped
Press the LIFTGATE button for at least one second
and release. The liftgate will open/close.
If the liftgate is locked and is not equipped with a
powered liftgate, pressing the button will result in
the liftgate becoming unlocked for 30 seconds
allowing you to manually access the liftgate area
only.
To Open/Close Left Power Sliding Door — If
Equipped
Press the LEFT button for at least one second and
release. The door will open/close.
16
If the vehicle is not equipped with a left power
sliding door and the door is closed and locked,
pressing the button will result in the left side doors
becoming unlocked.
To Open/Close Right Power Sliding Door — If
Equipped
Press the RIGHT button for at least one second
and release. The door will open/close.
If the vehicle is not equipped with a right power
sliding door and the door is closed and locked,
pressing the button will result in the right side
doors becoming unlocked.
To Turn Off "Button Delay" for Power
Features — If Equipped
1. Press the UNLOCK button for 5 to 10 seconds.
2. While the UNLOCK button is pressed, (after 5
seconds) press the LIFTGATE button. Release
both buttons.
When the "Button Delay" is turned off, the system
will respond immediately to the press of a button
(this may result in unwanted activations of a
powered feature or your leaving the vehicle in an
unsecured state).
The "Button Delay" feature can be reactivated by
repeating this procedure.
To Turn Off "Lamp Flash" (Optical Chirp) — If
Equipped
1. Press the LOCK button for 5 to 10 seconds.
2. While the LOCK button is pressed, (after 5
seconds) press the LIFTGATE button. Release
both buttons.
The "Lamp Flash" feature can be reactivated by
repeating this procedure. The table below ex-
plains the Lamp Flash options.
Function Which Turn
Signal Lamps
Lock All
Unlock 1st Left Side
Press
Unlock All All
Doors
Left Side Left Side
Right Side Right Side
Liftgate All
Number of
Flashes
1
2
2
2
2
2