Windshield Wiper Blades; Windshield, Headlight Washers, And Rear Window Washers - Chrysler Voyager 2001 Operating Information Manual

Smooth, White Body Lubricant (such as
Mopar Spray White Lube)
Door check straps
Parking brake mechanism
Liftgate latches
Liftgate prop pivots
Cup holders/Ash receiver
Front seat tracks
Sliding door rear latch striker shaft and wedge
Multi-purpose Lubricant (such as Mopar
Multi-Mileage Lubricant)
Sliding Door - center and upper tracks, and the
open position striker spring.
Points That Should Not Be Lubricated
There are many points that should not be lubri-
cated; some because they are permanently lubri-
cated, some because lubricants will be detrimen-
tal to the operating characteristics, and some
because lubricants will cause component failures.
In particular, rubber bushings should not be lubri-
cated, since this not only will cause them to fail,
but will destroy their necessary frictional charac-
teristics.
Parts that should NOT be lubricated are as fol-
lows:
134
Alternator bearings
Alternator Pulley
Belt Autotensioner
Belt idler pulleys
Drive belts
Front wheel bearings
Rear wheel bearings
Rubber bushings
Rubber isolator hangers
Speed Control Cable
Starter bearings
Suspension strut bearings
Throttle control cable
Water pump bearings

Windshield Wiper Blades

The rubber edges of the wiper blades and the
windshield should be cleaned periodically with a
sponge or soft cloth and a mild non-abrasive
cleaner. This will remove accumulations of salt or
road film.
Operation of the wipers on dry glass for long
periods may cause deterioration of the wiper
blades. Always use washer fluid when using the
wipers to remove salt or dirt from a dry windshield.
Avoid using the wiper blades to remove frost or
ice from the windshield. Keep the blade rubber
out of contact with petroleum products such as
engine oil, gasoline, etc.
Windshield, Headlight Washers, and
Rear Window Washers
The fluid reservoir for the windshield washers,
headlight washers (if equipped) and the rear
window washer is shared. It is located in the
engine compartment next to the air cleaner and
should be checked for fluid level at regular inter-
vals. Fill the reservoir with windshield washer
solvent (not radiator antifreeze) and operate the
system for a few seconds to flush out the residual
water.
The washer fluid reservoir can be filled with 5 liters
of washer fluid when the Low Washer Fluid Light
illuminates.