Assembling - Makita DJR187 Technical Information

5-1-2

Assembling

Apply soapy water onto the inner circumference of Insulation cover, and mount Insulation cover to Gear housing assembly by
thrusting it.
Note: Apply Loctite 272 on M6x14 Hex socket head bolt when you use it again. (Fig. 5-1-1-2-1)
5-2 Slider assembly
5-2-1 Disassembling
[1] Pull out Shoe. (Refer to 5-1 Insulation cover.)
Fig. 5-2-1-1
[2] Remove Protector.
[4] Remove Driving sleeve guide, Guide sleeve, Pin 3, Shoulder pin 5, Compression spring 6 and Driving sleeve.
Note: Be sure not to lose Shoulder pin 5 and Compression spring 6.
Fig. 5-1-2-1
[3] Insert a slotted screwdriver from the end of Retaining
Protector
screwdriver
Fig. 5-2-1-3
Driving
sleeve guide
Guide sleeve
Pin 3
7 / 24
Insulation cover
Gear housing
assembly
Fig. 5-2-1-2
ring 18, then pry it off.
Slotted
Shoulder pin 5 Compression
spring 6
Driving sleeve
Retaining
ring 18