Makita DJR187 Technical Information page 11

Fig. 5-2-2-9
[9] Mount Driving sleeve guide while aligning its notches
to the concaves of Sleeve.
Driving
sleeve guide
Fig. 5-2-2-11
[11] Mount Compression spring 6 and Shoulder pin 5 into the
holes of Guide sleeve/ Slider.
[13] Put Driving sleeve over Guide sleeve and secure them with Retaining ring (EXT) 18 using 1R291.
Then, install Protector to Driving sleeve.
Note: Fit its projections in the concaves of Sleeve and Driving sleeve guide.
Driving sleeve
Projection Guide sleeve
Concave of Sleeve and
Driving sleeve guide
Concaves of Sleeve
Compression
spring 6
Shoulder pin 5
Fig. 5-2-2-13
Retaining ring
(EXT) 18
11 / 24
Fig. 5-2-2-10
[10] Mount Guide sleeve.
Guide sleeve
Fig. 5-2-2-12
[12] Mount Pin 3.
Pin 3
Protector
Driving
sleeve
Retaining ring
(EXT) 18