Makita DJR187 Technical Information page 22

Wiring to Handle
Rib G
Put the flag receptacle
from Switch with its lead
wires facing Handle L
side.
Put the lead wires of
Switch between the rib B
and the rib C.
Rib C
Rib B
Put Noise suppressor with
·
Noise suppressor lead wire
(white) positioned over
Noise suppressor lead wire
(black).
Put Noise suppressor
·
between the rib C and the
inner wall A.
Put the following lead wires between the rib B and the rib D.
·
- the lead wires of Terminal
- the lead wires of LED circuit
- the lead wires of Stator
Put the lead wires (Orange, white) of Stator under the lead wires of Terminal.
·
Fig. 7-3
Put the lead wires of LED circuit between
Motor housing and the inner wall B.
Put the lead wires of LED circuit more toward
Handle R side than the rib G.
Switch
Noise suppressor
Inner
wall A Connector
Rib D
Rib E
Terminal
22 / 24
Handle L
Inner
wall B
Rib H
Put Closed end splices in this
space, do not put it on the rib H,
the boos B and the connector.
Rib F
Put the lead wires of Stator and LED circuit
·
between the rib E and the rib F.
Put the lead wires of Stator with tube under
·
the lead wires of Terminal and Stator.
Motor housing
Boss B