Rear-Panel Features - Agilent Technologies ESA Series Getting Started Manual

Rear-Panel Features

1 Power input
line-power source outlet has a protective ground contact.
2 DC Power
section in the specifications guide for your analyzer.
CAUTION AC line power and dc power should not be plugged in simultaneously.
3 Line Fuse
only with a fuse of the same rating. See the label on the rear panel.
4 Service Connector. The service connector is for service use only.
5 Inputs/Outputs (Refer to the specifications guide for more information.)
5a
5b
5c
Chapter 2
is the input for the ac line power source. Make sure that the
is the input for the dc power source. Refer to the "Power Requirements"
. The fuse is removed by twisting counterclockwise 1/4 turn. Replace
drives an external VGA compatible monitor with
VGA OUTPUT
a signal that has 31.5 kHz horizontal, 60 Hz vertical
synchronizing rate, non-interlaced.
GATE/HI SWP OUT (TTL)
or when Gate (Option 1D6) is active.
GATE TRIG/EXT TRIG IN (TTL)
external voltage input that triggers the analyzer internal sweep
source or the gate function (Time Gate, Option 1D6).
Front and Rear Panel Features
Rear-Panel Features
is high when the analyzer is sweeping
accepts the positive edge of an
31