Table of Contents
Advertisement
4.5
Adding devices
4.5.1
Project import from ABB-Welcome App
For commissioning you are located in:
Overview of commissioning:
Two modes are available for the connection. One mode must be selected during the course of
the steps.
"Residential" mode:
–
The ABB-Welcome App must be connected with the same router as the system controller
"Smart Access Point".
–
In this case the ABB-Welcome App locates the available system controller "Smart
Access Point"automatically.
"Functional" mode:
–
The smartphone is connected to system controller "Smart Access Point" via WLAN.
–
Here the smartphone must be located in the same address location [10.0.0.xx] as
system controller "Smart Access Point" [Error source].
To upload the project, perform the following steps:
1. Connect a PC with system controller "Smart Access Point" and call up system controller
"Smart Access Point" via a browser.
Fig. 30:
Main menu of system controller: Requesting project import
2. Start function "Upload" in the main menu.
System Manual 2CKA000073B9795
Commissioning
Setion 2 (Adding devices in the system)
– Section B: (Adding devices)
see chapter 4.1 "Overview of commissioning"
on page 30
│49
Advertisement
Table of Contents
