Table of Contents
Advertisement
4.3
Physical addresses ― Preparing and addressing devices viaABB-Welcome App
For commissioning you are located in:
Overview of commissioning:
On the rear side of each device are 2 stickers with the serial numbers of the device. One of
them is fitted with a QR code. This is necessary for the preparation of the device with the ABB-
Welcome App.
To add the devices, perform the following steps:
Fig. 22:
Configuration mode
1. Switch to "Configuration mode" in the ABB-Welcome App.
System Manual 2CKA000073B9795
Commissioning
Section 1 (Preparing the devices)
see chapter 4.1 "Overview of commissioning"
on page 30
│41
Advertisement
Table of Contents
