Table of Contents
Advertisement
4.2.3
Outdoor station without display
For commissioning you are located in:
Overview of commissioning:
The LEDs light up permanently during the automatic boot up.
Fig. 17:
Outdoor station without display: Engineering mode
To address the device, perform the following steps:
1. Activate "Engineering mode":
–
After the LED icons [1] in the camera have stopped being lit up, keep the top doorbell
button pressed for 11 seconds. In case of several bell spaces, the first doorbell button
below the audio shell [2].
–
The LEDs flash green.
2. Switch to the indoor station.
Fig. 18:
Outdoor station without display: Addressing via indoor station
System Manual 2CKA000073B9795
Section 1 (Preparing the devices)
see chapter 4.1 "Overview of commissioning"
on page 30
1
2
Commissioning
│35
Advertisement
Table of Contents
