Table of Contents
Advertisement
4.2.4
Outdoor station with display
For commissioning you are located in:
Overview of commissioning:
Fig. 19:
Outdoor station with display: Engineering settings
To address the device, perform the following steps:
1. Open the "Entry code" function in the standby mode.
2. In window "Password" enter the following: [#*] + settings password + [#]
–
The device switches automatically to window "Settings".
–
On the password, see the information at the end of this section.
3. Open the "Engineering settings" function.
4. In the area "Engineering settings" assign the physical address of the device.
The outdoor station is addressed.
System Manual 2CKA000073B9795
Commissioning
Section 1 (Preparing the devices)
see chapter 4.1 "Overview of commissioning"
on page 30
│37
Advertisement
Table of Contents
