Adding Devices - Preparation; Connecting A Pc With The "Smart Access Point" System Controller - ABB Welcome IP System Manual

4.4

Adding devices - Preparation

4.4.1

Connecting a PC with the "Smart Access Point" system controller

For commissioning you are located in:
Overview of commissioning:
Two modes are available for the later addition of the devices into the system. One mode must
be selected for the connection with the PC during the course of the steps.
"Residential" mode:
■
– The later IP address of system controller "Smart Access Point" must be determined on a
router.
"Functional" mode:
■
– The system controller "Smart Access Point" is called up by a browser via the static IP
address 10.0.0.1.
– For this the IP address of the PC must be located in the same address location.
Fig. 25: Connecting the system controller "Smart Access Point" with the PC
As soon as system controller "Smart Access Point" is supplied with voltage via the PoE switch,
the device boots up automatically.
System Manual 2CKA000073B9795
Commissioning
Section 2 (Adding devices in the system)
– Section A: (Connecting system controller
with a PC)
see chapter 4.1 "Overview of commissioning"
on page 30
│44