Parking Brakes; Leg Rest Length - Vermeiren Inovys Series Installation Manual

EN
NL
Adjust the backrest depth at the toothed clamps (19) of the brackets:
1. Remove the backrest.
2. Loosen the socket screw (18) of the toothed clamp (19).
3. Move the bracket forward/backward, but make sure that all teeth of the clamp stay
PL
covered.
CS
4. Retighten the socket screw.
5. Repeat this adjustment for the other brackets/clamps. Make sure all 4
brackets/clamps are adjusted identically.
6. Mount the backrest in place.

Parking brakes

3.5
CAUTION
Adjust the parking brakes after adjustment on the rear- wheel
position, and when tyres are worn to compensate the wear.
Adjust the correct braking force of the parking brakes:
1. Release the brake, see user manual.
2. Loosen the socket screws (22) to make the brake free to slide.
3. Slide the brake over the guide (23) to the desired position.
4. Retighten the socket screws (22).
5. Verify if the brake is working properly: the wheel is blocked, but
the brake can be operated easily. If this is not the case, repeat the steps above until the
brakes are adjusted well.
6. Repeat for the second parking brake. Make sure that both brakes are adjusted
identically.

Leg rest length

3.6
CAUTION
The maximum length of the footrest is limited to the length
indicated by a triangle on the front of the footrest tube, see
picture. This maximum length adjustment is not possible in sitting
position; the footplates will touch the ground.
Make sure that the distance to the ground in sitting position is
minimal 60 mm to avoid touching small obstacles and to prevent
damage to the footrest.
Risk of injuries
Risk of injuries or damage
Installation manual
- 8 -
Inovys wheelchairs
2019-02
Adjustments
22
23