Adjusting The Parking Brakes; Adjusting The Angle Of The Rear Wheels; Adjusting Of The Foot Bracket; 4.5.1 Length Of The Foot Bracket - Vermeiren Sagitta Installation Manual

EN
NL
4.3

Adjusting the parking brakes

Depending on the diameter of the rear wheels and their position, the brakes can be adjusted
accordingly. The following instructions apply to both the push-pull brakes and the sports brakes.
1. Release the brake, see user manual.
2. To move the brake forwards/backwards:
a. Loosen the two screws (34) connecting the
brake to the frame.
b. Slide the brake forwards/backwards until the
desired position (clamp over frame tube, or
brake attachment tube in clamp).
3. To move the brake sideways:
a. Loosen the two screws (35) connecting the
brake to the attachment tube.
b. Slide the brake sideways until the desired
position.
4. Firmly retighten both screws.
5. Verify if the brake is working properly; the wheel is
blocked, but the brake can still be operated easily.
If this is not the case, repeat the steps above until
the brake is adjusted well.
6. Repeat for the second parking brake. Make sure that both brakes are adjusted identically.
4.4

Adjusting the angle of the rear wheels

4.5

Adjusting of the foot bracket

4.5.1 Length of the foot bracket

L WARNING: Risk of injury – Make sure that before using the foot bracket the screws are
tightened by hand.
L CAUTION: Risk of damage – Avoid that the foot bracket make any contact with the
ground. Keep a minimum distance from 30 mm above the ground.
The angle of the rear wheels is adjustable in 5 sizes (0°, 2°, 4°,
6°, 8°) by changing the axle  of the rear wheels.
Installation manual
9
Sagitta, Sagitta SI
Assembly and adjustments
35
34
2023-07