Silvercrest SV 60 A1 Assembly, Operating And Safety Instructions page 10

Cleaning and user maintenance
shall not be made by children
without supervision .
Ensure the rated voltage shown
on the rating label corresponds
with the voltage of the power
supply .
Do not operate any product with
a damaged power cord or plug,
when the product malfunctions
or has been damaged in any
manner .
Only use the product in dry
indoor rooms .
Do not operate the product with
wet hands or while standing on a
wet floor . Do not touch the power
plug with wet hands .
Protect the product against heat .
Do not place the product close to
open flames or heat sources such
as stoves or heating appliances .
Do not insert fingers or foreign
objects in any opening of the
product and do not obstruct the
air vents .
Regularly check the power plug
and power cord for damage .
If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard .
Protect the power cord against
damages . Do not let it hang over
sharp edges, do not squeeze or
bend it . Keep the power cord
away from hot surfaces and
open flames and ensure that
nobody can pull on or trip over it
unintentionally .
If the power cord should
overheat, stop using the product
and disconnect the product from
the electrical outlet .
Do not pull the power plug out of
the electrical outlet by the power
cord . Do not wrap the power
cord around the product .
Protect the product, its power
cord and power plug against
dust, direct sunlight, dripping and
splashing water .
For safety reasons, it is
recommended not to remove the
safety grille/guard . However, if
you need to remove it, ensure that
the product is switched off from
the supply mains before removing
the grille/guard .
Never use the product without the
safety grille or with a damaged
safety grille .
Place the product on a firm, level
and stable surface to prevent
overturning during operation .
GB 9