Before Use; Unpacking; Inserting/Replacing The Battery - Silvercrest SV 60 A1 Assembly, Operating And Safety Instructions

If you think batteries might have
been swallowed or placed inside
any part of the body, seek imme-
diate medical attention .
Risk of leakage of batteries /
rechargeable batteries
Avoid extreme environmental
conditions and temperatures,
which could affect batteries /
rechargeable batteries, e .g .
radiators / direct sunlight .
If batteries / rechargeable
batteries have leaked, avoid
contact with skin, eyes and
mucous membranes with the
chemicals! Flush immediately the
affected areas with fresh water
and seek medical attention!
WEAR PROTECTIVE
GLOVES!
Leaked or damaged batteries /
rechargeable batteries can cause
burns on contact with the skin .
Wear suitable protective gloves
at all times if such an event oc-
curs .
In the event of a leakage
of batteries / rechargeable
batteries, immediately remove
them from the product to prevent
damage .
Remove batteries / rechargeable
batteries if the product will not be
used for a longer period .
Risk of damage of the
product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (–) on the
battery / rechargeable battery
and the product .
Clean the contacts on the
battery / rechargeable battery
before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately .
˜ Before use
˜ Unpacking
Remove the packaging . Check if all parts are
complete .
˜ Inserting/Replacing the battery
For first time use, pull out the insulation strip from
the battery compartment
Open the battery compartment
the battery receptacle (located at the back of
the remote control
Remove the used battery if present .
Insert a button cell (type CR2025) into the
battery receptacle . The + polarity marking has
to point upwards .
Slide the battery receptacle back into the battery
compartment .
30
.
30
by pulling out
30
31 (Fig . H) .
GB 11