Viewing Rip Interface Information - HP 2920 Series Multicast And Routing Manual

Viewing RIP interface information

To display RIP interface information, enter the show ip rip interface command at any
context level.
Syntax:
show ip rip interface [ ip-addr | vlan <vlan-id> ]
The resulting display will appear similar to the following:
Example 30 Output for the show IP RIP interface command
HP Switch(config)# show ip rip interface
RIP interface information
IP Address
----------- -------- ---------- ---------- ------- ----
100.1.0.1
100.2.0.1
100.3.0.1
100.4.0.1
You can also display the information for a single RIP VLAN interface, by specifying the VLAN ID
for the interface, or by specifying the IP address for the interface.
To show the RIP interface information for VLAN 1000, use the show ip rip interface vlan
<vid> command.
Example 31 RIP interface output by VLAN
HP Switch# show ip rip interface vlan 4
RIP configuration and statistics for VLAN 4
RIP interface information for 100.4.0.1
IP Address : 100.4.0.1
Status
Send Mode
Recv mode
Metric : 1
Auth : none
Bad packets received : 0
Bad routes received
Sent updates : 0
For definitions of the fields in
58 IP Routing Features
IP address
Bad routes
Last update timeticks
Status Send mode
enabled V2-only
enabled V2-only
enabled V2-only
enabled V2-only
: enabled
: V2-only
: V2-only
: 0
Example 31, see
IP address of the RIP neighbor.
Number of route entries which were not
processed for any reason.
Number of seconds that have passed since
we received an update from this neighbor.
Recv mode Metric
V2-only 1
V2-only 1
V2-only 1
V2-only 1
"Viewing general RIP information" (page
Auth
none
none
none
none
56).