HP 2920 Series Multicast And Routing Manual page 57

Example 29 General RIP information listing
HP Switch(config)# show ip rip
RIP global parameters
RIP protocol : enabled
Auto-summary : enabled
Default Metric : 1
Distance : 120
Route changes : 0
Queries : 0
RIP interface information
IP Address Status
----------- -------- --------- ---------- ------- ----
100.1.0.1 enabled
100.2.0.1 enabled
100.3.0.1 enabled
100.4.0.1 enabled
100.10.0.1 enabled
100.11.0.1 enabled
RIP peer information
IP Address
--------------- ----------- ---------------------
The display is a summary of global RIP information, information about interfaces with RIP enabled,
and information about RIP peers. The following fields are displayed:
RIP protocol
Auto-summary
Default metric
Route changes
Queries
RIP interface information
RIP peer information
Send mode Recv mode
V2-only V2-only
V2-only V2-only
V2-only V2-only
V2-only V2-only
V2-only V2-only
V2-only V2-only
Bad routes Last update timeticks
Status of the RIP protocol on the router. RIP must be enabled here and on the
VLAN interface for RIP to be active.
The default is disabled.
Status of auto-summary for all interfaces running RIP. If auto-summary is
enabled, subnets will be summarized to a class network when advertising
outside of the given network.
Sets the default metric for imported routes. This is the metric that will be
advertised with the imported route to other RIP peers. A RIP metric is a
measurement used to determine the "best" path to network: 1 is the best, 15
is the worst, 16 is unreachable.
The number of times RIP has modified the routing switch's routing table.
The number of RIP queries that have been received by the routing switch.
RIP information on the VLAN interfaces on which RIP is enabled:
IP address
Status
Send mode
Recv mode
Metric
Auth
RIP peers are neighboring routers from which the routing switch has received
RIP updates:
Metric Auth
5 none
5 none
5 none
5 none
5 none
5 none
IP address of the VLAN interface running RIP.
Status of RIP on the VLAN interface.
Format of the RIP updates: RIP 1, RIP 2, or RIP 2 version 1
compatible.
The switch can process RIP 1, RIP 2, or RIP 2 version 1
compatible update messages.
Path "cost", a measurement used to determine the "best" RIP
route path: 1 is the best, 15 is the worst, 16 is unreachable.
RIP messages can be required to include an authentication
key if enabled on the interface.
Configuring RIP 57