Errors From Ethernet/Ip - Siemens SIMATIC Ident Function Manual
Rfid systems. ident profile, add-on instruction for rockwell systems
Hide thumbs
Also See for SIMATIC Ident:
- System manual (362 pages) ,
- Function manual (142 pages) ,
- Operating manual (80 pages)
Table of Contents
Advertisement
Error messages
5.3 Errors from Ethernet/IP
5.3
Errors from Ethernet/IP
The transport layer of the bus system being used (Ethernet/IP) is signaling an error. For
precise troubleshooting and analysis, a tracer can be useful. For Ethernet/IP, the open
source software "Wireshark" can be used. The system diagnostics of Ethernet/IP can
provide further information about the cause of the error.
With error messages output via the "STATUS" parameter of the Ident profile that are not
contained in the section "Errors from the communications module/reader (Page 104)" you
need to read out the following data ("Controller Tags") of the instance "WRREC" or
"RDREC". The "MESSAGE" instruction outputs two error codes. One standard error code
that is displayed via "STATUS" and the instance "WRREC" or "RDREC" in the "ERR"
variable and an extended error code that is displayed in the "EXERR" variable.
Figure 5-1
You will find a description of these error codes in the help of the "RSLogix" configuration
software.
110
Tags of the "MESSAGE" instruction
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
Advertisement
Table of Contents
