Siemens SIMATIC Ident Function Manual page 63

● IDENT_DATA_RXREF
● HW_CONNECT
● MSG_READ
● MSG_WRITE
● STATUS_WORD
● CONTROL_WORD
Example of parameter assignment
IdentProfile
Create a instance variable.
CMDREF
Assign a variable to the "CMDREF" parameter. This variable has the
"IID_CMD_STRUCT[10]" data type.
HW_CONNECT
Assign a variable to the "HW_CONNECT" parameter. This variable is part of the variables of
the "IID_DATA_*" type.
IDENT_DATA_TXREF
Assign a variable to the "IDENT_DATA_RXREF" parameter. This variable has the "SINT[n]"
data type.
IDENT_DATA_RXREF
Assign a variable to the "IDENT_DATA_RXREF" parameter. This variable has the "SINT[n]"
data type.
STATUS_WORD and CONTROL_WORD
Assign the cyclic input word to the STATUS_WORD parameter and the cyclic output word for
the channel to the CONTROL_WORD parameter. Per physical module, variables are
automatically created for the cyclic words.
The "I" stands for input and the "O" for output as shown in the following figure. These are
assigned as follows:
● Input for STATUS_WORD: ...I.Data...
● Output for CONTROL_WORD: ...O.Data...
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
Configuring the instructions
4.6 Programming the Ident profile
63