Download  Print this page

Certificates And Approvals; Connecting The Hardware; Connecting An Ethernet-based Reader - Siemens SIMATIC Ident Operating Manual

Hide thumbs



Certificates and approvals

Table 3- 11
Industry Canada Radio
Standards Specifications

Connecting the hardware


Connecting an Ethernet-based reader

Connecting an Ethernet-based reader in an isolated test environment
To set up or to diagnose an Ethernet-based reader RF640R/RF670R, you can connect the
reader to the PC using a crossover cable or an Ethernet adapter capable of cross-linking.
Figure 3-3
Reader parameter assignment with RF-MANAGER Basic
Remember that you assign parameters and correct the readers using the RF-MANAGER
Basic. SIMATIC RF-DIAG is used only to check the current settings.
Note that the reader cannot communicate with more than one software tool at any one time.
You will find further information on connecting up and assigning parameters for an Ethernet-
based reader in the manual "RF-MANAGER Basic".
Operating Manual, 09/2012, C79000-G8976-C292-01
Certificates and approvals for the PC adapter
CE approval complying with 2004/108/EC EMC
FCC Rules, Part 15, Subpart B, Sections 15.107 and 15.109
CAN/CSA-CISPR 22-10 - Information technology equipment – Radio
disturbance characteristics – Limits and methods of measurement
Connecting Ethernet-based readers to a PC
Connecting hardware
3.2 Connecting the hardware


   Also See for Siemens SIMATIC Ident

   Related Manuals for Siemens SIMATIC Ident

This manual also for:

Simatic rf-diag

Comments to this Manuals

Symbols: 0
Latest comments: