Badger Meter FC-5000 User Manual page 37

Problem Possible Causes
1�
Some of the
2�
keys on the
control panel are
not operational�
3�
Display Overrun
There are more digits to display
Error (Shown as
than the maximum quantity�
"DISPOVR")
1�
Alarm
notification from
the Home screen
1�
"R1" and/or
"R2" appear on
2�
home screen
1�
"DISABLED"
displays on
home screen
THERE ARE NO FIELD-REPLACEABLE PARTS INSIDE. OPENING THE UNIT WILL VOID ALL
WARRANTIES.
If a repair or evaluation from the factory is required, call your local representative
or the factory to obtain a Return Material Approval (RMA)�
The shipping address, RMA number and any other required information will be
provided to send the unit to an appropriate location�
Company Website
Customer Service Email
Customer Service Number
April 2019
Broken switch behind
control panel�
Function not available on
this model�
Problem with internal
components�
The rate or total values
indicated on the Home Screen
are in an overrun condition
(value exceeds 8 digits)
Relay 1 and/or Relay 2
are latched
Relay 1 and/or 2 are energized
Flow sensor type setting set to
"NO SENSOR/DISABLED"
Table 22: Troubleshooting
Table 23: Contact information
CTL-UM-02765-EN-01
Oemedies
1� Replace the Flow Display�
2� See "Operator Interface" on
3� Return the Flow Display to the factory
for repair�
4� Cycle the power to the Flow Display
1� Check the unit of measure and change
to a larger unit if possible (for example,
change gallons to mega gallons)
2� Check the display precision and reduce
it, if possible�
1� Change the unit of measure associated
with the parameter (see
on page 27) or reset the totalizer (see
"Resets" on page 25)�
1� See "Clearing a Latched Relay" on
page 26
2� The programmed alarm conditions are
met� Check process or programming
1� Configure a flow sensor� See
"Configuring a Flow Sensor" on page 29
www�badgermeter�com
indorders@badgermeter�com
(877) 243–1010
Troubleshooting
page 17�
"Unit of Measure"
Page 37