Superi/O Configuration Submenu - Seco Qseven Q7-974 User Manual

4.3.13 SuperI/O configuration submenu

Menu Item Options
Name of the SuperI/O found
Keyboard Controller Enabled / Disabled
Serial Port 1 / Serial Port 2 /
Enabled / Disabled
Serial Port 3 / Serial Port 4
0x3F8 / 0x2F8 / 0x3E8 / 0x2E8
/ 0x3E0 / 0x2E0 / 0x338 /
Address
0x238 / 0x220 / 0x228
3 / 4 / 5 / 6 / 7 / 10 / 11 / 14 /
IRQ
15
Floppy Disk Controller Enabled / Disabled
Parallel Port Mode Parallel Port / External FDC
LPT Port Enabled / Disabled
SPP / EPP 1.9 and SPP / ECP
/ ECP-EPP 1.9 / Printer Mode /
LPT Mode
EPP 1.7 and SPP / ECP-EPP
1.7
LPT Irq Disabled / 5 / 7
Hardware Monitor Enabled / Disabled
Disabled / 1 Minute / 2 Minutes
Watchdog
/ 3 Minutes
Q7-974
Q7-974 User Manual - Rev. First Edition: 0.1 - Last Edition: 2.3 - Author: S.B. - Reviewed by G.G. Copyright © 2017 SECO S.r.l.
Description
This menu item will show the name of all the Super I/Os that are found on the carrier board. By selecting the
adequate SuperI/O, it will be possible to set the serial ports and possibly other parameters as shown in the
following menu items. If no Super I/O is available on the Carrier Board, this menu will not be available.
Enable / disable the Keyboard Controller (if the SuperI/O supports it, otherwise this item will not be available).
Enable or Disable single serial port #1, #2, #3 or #4 (the number of serial ports depends on the Super I/O).
Select the Base address for each Serial Port, if enabled.
Select the IRQ line to assign to each Serial Port, if enabled.
Enable / disable the Floppy Disk Controller, if the SuperI/O supports it
Configure the Parallel Port mode of working, if the SuperI/O supports it
When the previous item is set to "Parallel Port", this item will allow to enable or disable the LPT port.
When the LPT port is enabled, this item will allow to configure the LPT protocol
When the LPT port is enabled, this item will allow to configure the LPT IRQ
Enable or disable the Super I/O Hardware monitor (if it is supported by the Super I/O)
Enable or Configure the Super I/O Watchdog (if the Super I/O Used supports it, otherwise this item will not
be available)
60