Table of Contents
Advertisement
4.3.9 Chipset configuration submenu
Menu Item
Options
PCI 64-bit Decode
Enabled / Disabled
CRID
Enabled / Disabled
4.3.10 SATA configuration submenu
Menu Item
Options
SATA Controller
Enabled / Disabled
Sata Port 0
Enabled / Disabled
Sata Port 1
Enabled / Disabled
IDE
Chipset SATA Mode
AHCI
SATA Speed
Gen1 / Gen2
SATA Port 0 Hot Plug Capability
Enabled / Disabled
SATA Port 1 Hot Plug Capability
Auto
Ultra ATA/100
IDE Max Transfer Mode
Ultra ATA/66
Ultra ATA/33
PIO Mode
Native IDE
IDE Mode
Legacy IDE
Serial ATA Port 0 / 1
Q7-974
Q7-974 User Manual - Rev. First Edition: 0.1 - Last Edition: 2.3 - Author: S.B. - Reviewed by G.G. Copyright © 2017 SECO S.r.l.
Description
Allow system to support 64-bit BAR (Base Address Register) for PCI devices.
Enable / Disable CRID (Configured Revision ID) register.
Description
Disabled: Disables SATA Controller. All following items will be disabled
Enabled: Enables SATA Controller
Enables or disable SATA Port #0
Enables or disable SATA Port #1
Set SATA Configuration type
With AHCI, is not possible to install/boot UEFI O.S., only Legacy OS can be installed (a simpler driver is
required).
Setting to IDE, the controller is managed as a PCI device, so addresses reallocation and INT line sharing is
possible.
Select SATA speed
These items will be available only when "Chipset SATA Mode" is set to AHCI.
If enabled, SATA port will be reported as Hot Plug Capable
This item will be available only when "Chipset SATA Mode" is set to IDE.
Sets the IDE Interfaces' maximum Transfer Rate
This item will be available only when "Chipset SATA Mode" is set to IDE.
Sets the IDE Working Mode
Shows information related to eventual devices connected to SATA ports 0 or 1
57
Advertisement
Table of Contents
