Console Redirection Submenu - Seco Qseven Q7-974 User Manual

4.3.11 Console Redirection submenu

Menu Item Options
Console Serial Redirect Enabled / Disabled
VT_100 / VT_100+ /
Terminal Type
VT_UTF8 / PC_ANSI
115200 / 57600 / 38400 /
Baud rate 19200 / 9600 / 4800 / 2400
/ 1200
Data Bits 7 bits / 8 bits
Parity None / Even / Odd
Stop Bits 1 bit / 2 bits
None
Flow Control RTS/CTS
XON/XOFF
0 Seconds / 2 Seconds / 5
Information Wait Time Seconds / 10 Seconds / 30
Seconds
C.R. After Post Yes / No
AutoRefresh Enabled / Disabled
FailSafeBaudRate
ACPI SPCR Table Enabled / Disabled
Addr
Serial Port 0 - IRQy
Serial Port 1 - Addr IRQy
See following menu items
Serial Port 2 - Addr IRQy
Addr
Serial Port 3 - IRQy
PortEnable Enable / Disabled
UseGlobalSetting Enable / Disaled
Q7-974
Q7-974 User Manual - Rev. First Edition: 0.1 - Last Edition: 2.3 - Author: S.B. - Reviewed by G.G. Copyright © 2017 SECO S.r.l.
Description
Enable or disable Console redirection. When enabled, all the submenus of the following paragraph will appear
Set Console Redirection terminal type
Set Console Redirection baud rate
Set Console Redirection data bits
Set Console Redirection parity bits
Set Console Redirection stop bits
Set Console Redirection flow control type
Set Console Redirection port information display time
Console Redirection continues to work even after Bios POST.
When this feature is enabled, the screen will auto refresh once after detecting the connection of a remote
terminal
This feature will auto detect remote terminal baud rate and connect C.R serial device with detected baud rate
Serial Port Console Redirection Table.
When this feature is enabled, the SPCR table will be add-into ACPI tables.
These voices will be available only when Console Serial Redirect is Enabled and if at least one LPC Super I/O
is present on the carrier board.
Depending on the SuperI/O(s) found on the carrier board, this item will show the serial ports that are available,
with their address and IRQ (assigned). For each port it will be possible to set the paramters shown in the
following lines
Enable / Disable single serial Port x for the console redirection
Use or not global settings for Serial Port x for the console Redirection
58