Smarc rel. 2.1.1 compliant module with the intel atom x6000e series and intel pentium and celeron n and j series processors (formerly elkhart lake) for fusa applications (52 pages)
Rel. 2.1 compliant module with the intel atom x series, intel celeron j / n series and intel pentium n series (formerly apollo lake) processors (73 pages)
Page 1
SM-B71 SMARC Rel. 2.0 compliant module with the ® ® Xilinx Zynq Ultrascale+ MPSoC...
Page 2
SECO S.p.A. reserves the right to change precise specifications without prior notice to supply the best product possible. For further information on this module or other SECO products, but also to get the required assistance for any and possible issues, please contact us using the dedicated web form available at https://www.seco.com...
Page 6
1.3 RMA number request To request an RMA number, please visit SECO’s web-site. On the home page, please select “Contact us” then “Online RMA” and follow the procedure described. An RMA Number will be sent within 1 working day (only for on-line RMA requests).
Page 14
” ” Dimensions: 50 x82 mm (1.97 x 3.23 ** Measured at any point of SECO standard heatspreader for this product, SD 4-bit interface during any and all times (including start-up). Actual temperature will widely QuadSPI Flash depend on application, enclosure and/or environment. Upon customer to consider application-specific cooling solutions for the final system to keep the heatspreader temperature in the range indicated.
2.3 Electrical Specifications According to SMARC specifications, the SM-B71 module can be supplied with an external voltage in the range +3V ÷ +5.25V For Real Time Clock working and CMOS memory data retention, it is also needed a backup battery voltage. All these voltages are supplied directly through card edge fingers (see connector’s pinout).
Linux SECO will offer the BSP (Board Support Package) for these O.Ss, to reduce at minimum SW development of the board, supplying all the drivers and libraries needed for use both with the SMARC board and the Carrier Board, assuming that the Carrier Board is designed following SECO SMARC Design Guide, with the same IC’s.