Recharge - ProLights DOTQ User Manual

8

3.3 RECHARGE

To recharge DOTQ:
• plug the power cable into a mains socket (100-240V ~ / 50-60Hz).
• connect the unit to the special battery charger through the lower connector
• If the light is connected to the charger, the CHARGE LED will turn on
NOTE - DOTQ's autonomy is up tp 16 h in color change mode and up to 6h in full-on white.
Charging time: up to 3h.
3.4 MENU
To enter in the DOTQ's menu, use the IR controller included in the DOTQPACK.
With the IR controller you can:
• Power ON/OFF the light
• Setup the DMX address
• Setup the W-DMX connection
• Select a static color
• Choose the dimmer of the light
3.5 CONTROLLER IR
Make sure to point the controller directly at the receiver on
the product.
doTQ
Fig. 4