Installation; Mounting; Functions And Settings; Operation - ProLights DOTQ User Manual

doTQ
7

- 2 - INSTALLATION

2.1 MOUNTING

DOTQ may be set up on a solid and even surface. The unit can also be mounted upside down to a cross
arm. For fixing, stable mounting clips are required. The mounting place must be of sufficient stability and
be able to support a weight of 10 times of the unit's weight.
When carrying out any installation, always comply scrupulously with all the regulations (particularly re-
garding safety) currently in force in the country in which the fixture's being used.
IMPORTANT
Always additionally secure the projector with the safety rope from falling down. For this purpose, fasten
the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm.

- 3 - FUNCTIONS AND SETTINGS

3.1 OPERATION

Switch on the DOTQ with the power switch. The unit is ready for operation and can be operated via a DMX
controller or it independently performs its show program in succession.
After operation, switch off the unit with the power switch.

3.2 BASIC SETUP

The DOTQ has a LED display used to DMX /RDM addressing and 3 status LEDs (p 3.6).
Wireless Led
Power Led
Charge Led
IR
Fig. 3