gako unguator EMP Quick Start Manual page 43

• After-sales service and maintenance service are billed for expenses and wear parts at
reasonable price, according to the cost estimate within the warranty period as well
• Upon request a gako unguator Loaner may be provided for a one-time charge that can be
used while your gako unguator is away for maintenance and repair
Notes on Safety
• gako unguator Devices must only be connected to grounding type receptacles with
230 V / 50 Hz(cps); 120 V / 60 Hz(cps) or rated country specific voltage installed accor-
ding to the regulations of DIN VDE 0100
• gako unguator Devices have been designed for operation under normal room atmos-
pheric conditions. Recommended values: Ambient temperature between 15 - 30 °C / 59
- 86 °F and relative air humidity less than 80 %
• The device should be allowed to acclimatize for approx. 30 minutes at initial commissio-
ning and/or after extended storage time in cold rooms
• the gako unguator EMP should be placed to ensure easy access to the power switch and
power cable also to avoid use by unauthorized persons
• Do not immerse gako unguator Devices in water
• Electronics part should just be dis- and assembled by a certified service partner
• Only operate the gako unguator Stirrer inside a closed gako unguator Jars
• Do not touch rotating parts.
• Keep long hair away from rotating parts.
• During the automated lifting of the gako unguator EMP: always keep long hair, body parts
or objects away from the lifting mechanism. Immediately turn off the power switch in
case of an emergency or pull the power plug.
• Using the gako unguator Devices not according to these operating instructions or with
line products that the manufacturer did not deliver or recommend may impair safety.
• gako unguator Devices have not been designed for operation under hazardous condi-
tions. Heed the relevant safety regulations when handling hazardous substances (e.g.
combustible liquids such as alcohol or similar substances).
• gako unguator Devices correspond to the safety standards for laboratory equipment.
They have to be positioned to prevent any interference or use by unauthorized persons.
• The device must not be disposed of in ordinary domestic waste. Please deliver the device
to the available collecting and recycling systems at the end of its life cycle.
contact@unguator.com | unguator.com
chapter 6 - page 2