Replacing An Existing Module - IBM Aptiva Handbook

2.
Position the new cache module over the cache
socket so that the notch at the bottom of the
module lines up over the divider in the socket. As
shown in the next picture, match the wide part of
the module to the wide part of the opening in the
socket.
To insert cache module:
Position bottom notch over
socket divider as shown.
notch
The module can be installed only when the notch
Important:
is aligned correctly.
cache
memory module
cache memory
module socket
cache memory
module socket
3.
Push the module straight down into the socket.
A properly-inserted module looks like this:

Replacing an existing module

If you want to upgrade from 256KB of cache memory to
512KB of cache memory, you must replace the existing
256KB module with a 512KB module.
To replace an existing module, remove the installed
module by pulling straight up on the module. Then
follow the instructions in "Inserting a new module" on
page 66 to install the new module.
Installing cache memory modules 67