IBM Aptiva Handbook page 110

Installing a drive in bay 3 (continued)
3.
Right bracket replacement
Slide the right bracket into the bay. Make sure you
insert the catch into its slot on the front of the
system unit. Also make sure the riser card is
located to the left of the bracket.
Align the screw holes. Insert the two front screws
first, then insert the remaining screws. (The riser
card should be located to the left of the bracket so
that the screws go through the riser card first.)
Right Bracket
Catch
(Front View)
96 Chapter 7: Adding and removing adapter cards and drives
4.
Riser Card
Signal Cable
Hard disk cable connections
Connect all drive cables. Reinstall any drives you
removed in bays 1 and 2. For instructions on
installing a drive in bay 1, see "Installing a drive in
bay 1" on page 91. For instructions on installing a
drive in bay 2, see "Installing a drive in bay 2" on
page 93.
Drive
(Back View)
Power Cable