Siemens CP 1243-1 Operating Instructions Manual page 35

Table 3- 1 Dimensions for installation (mm)
S7-1200 devices
CPU (examples)
Communications inter-
faces (examples)
* Width B: The distance between the edge of the housing and the center of the hole in the DIN rail mounting clip
You will find detailed dimensions of the module in the section Dimension drawings
(Page 139).
DIN rail clamps, control panel installation
All CPUs, SMs, CMs and CPs can be installed on the 35 mm DIN rail in the cabinet. Use the
pull-out DIN rail mounting clips to secure the device to the rail. These mounting clips also
lock into place when they are extended to allow the device to be installed in a switching
panel. The inner dimension of the hole for the DIN rail mounting clips is 4.3 mm.
Installation location
NOTICE
Installation location
The module must be installed so that its upper and lower ventilation slits are not covered,
allowing adequate ventilation. Above and below the device, there must be a clearance of 25
mm to allow air to circulate and prevent overheating.
Remember that the permitted temperature ranges depend on the position of the installed
device. You will find the permitted temperature ranges in the section Technical
specifications of the CP 1243-1 (Page 133).
Device position / permitted temperature range
Horizontal installation of the rack
Vertical installation of the rack:
CP 1243-1
Operating Instructions, 04/2017, C79000-G8976-C365-03
CPU 1211C, CPU 1212C
CPU 1214C
CM 1241, CM 1243-5, CM 1242-5
CP 1242-7, CP 1243-1, CP 1243-7, CP 1243-8 IRC
Installation, connecting up, commissioning
3.2 Installing, connecting up and commissioning
Width A
90 mm
110 mm
30 mm
30 mm
Installation location
Width B *
45 mm
55 mm
15 mm
15 mm
35