Advertisement
Technical Note: MicroHAWK ID-40 360
20.2.
In the WebLink display area, click the button circled in the image above so that it is highlighted blue. This
enables Show All Images Used in Read Cycle. The image in the upper left will be the first image captured
and the last image will be the rightmost image on the bottom row. The image with the green graphics
over the barcode is the image in which the symbol was decoded.
20.3.
Run a product without a barcode past the readers so that all images in the read cycle can be displayed.
Ensure that the product moves from one side of the image to the opposite side for best performance, as
shown in the example below.
20.4.
If the product has completely moved beyond the image in the last image captured, reduce the Delay
Between Images to a shorter time.
20.5.
If the product did not move enough, increase the Delay Between Images to a longer time.
20.6.
Once the image capture delay has been set correctly, click the Save button to save changes to
the reader.
20.7.
Repeat steps 20.1 through 20.6 for all ID-40 readers.
32
Barcode Reading Solution
º
TECHNICAL
NOTE
Advertisement
