Advertisement
Technical Note: MicroHAWK ID-40 360
Transfer EtherNet/IP Configuration to NJ/NX Controller
14.
Check EtherNet/IP Communications
14.1.
Ensure that SYSMAC Studio is online with the controller by verifying that there is an orange line under
the toolbar. If necessary, click the "Online" button, which is identified by a red circle in the image below.
14.2.
With SYSMAC Studio online, click "Transfer to Controller" as shown below.
14.3.
Click "Yes" to complete the Transfer as seen below on the left. If the controller is in Run mode, you will see
the window shown below on the right. Click "Execute the Transfer to Controller operation in RUN mode".
24
Barcode Reading Solution
º
TECHNICAL
NOTE
Advertisement
