Advertisement
Technical Note: MicroHAWK ID-40 360
Omron NJ Controller Direct USB Connection
This type of connection can be used for modifications to NJ/NX settings (such as the IP Address) or changes to
logic, but for full configuration and testing of EtherNet/IP, use the Ethernet connection described in step 7 of the
section "Omron NJ/NX Controller Ethernet Connection via a Hub".
6. NJ Direct USB Connection
6.1.
Connect a USB cable from a PC to the PLC's USB port.
6.2.
Click Controller menu > Communications Setup as shown below.
6.3.
Click the "Direct Connection via USB" button as shown below.
6.4.
Click "USB Communication Test".
6.5.
Be sure "Test OK" shows in the white bar as shown below. This indicates that you have good
communications with the Omron controller.
6.6.
Click "OK" when ready.
12
Barcode Reading Solution
º
TECHNICAL
NOTE
Advertisement
