Installation And Connection; Power Connection; Video Signal Connection; Network Connection - Kiloview N Series User Manual

N Series Encoder·User Manual

4 Installation and connection

4.1 Power connection

Use the standard power adapter (DC 12V) to connect the device, after power on, the device charges the
built-in battery. Press the power switch on the device for more than 3 seconds. The power light flashes
and the device starts up.
If it is used in the mobile status, it can be powered by the built-in battery directly. Press the power switch
to start working (the built-in battery can last for about 4 hours).
About built-in battery:
1. While the device is powered on, connected with the power adapter, the device is powered by the
adapter. The battery is not charging.
2. While the device is powered off, connected with the power adapter, the battery will be charging.
About fan
1. While the device is powered on, the fan will start working when reaches a certain temperature.
2. While the device is powered off, the fan is working while charging.
Note: Please use the standard power adapter provided. Using other unqualified power
supplies may damage the device.

4.2 Video signal connection

Connect the SDI/HDMI signal from a source (such as a camera) to the input port of the device through a
cable.
N1: SDI input; N2: HDMI Input

4.3 Network connection

Plug the USB to RJ45 adaptor into the USB port of the device. The network port is connected to the
switch, or it can be directly connected to the computer network.
Version 1.0 © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
6