Table of Contents
Advertisement
Welcome screen
Language setting
Date setting
* A reset to factory settings is normally not necessary. If still desired, contact us for the password.
8.2
Quick settings
Press the power button, and the device automatically displays the central user interface. To get
into the mode where you set the parameters for the measurement, press the "Menu" button:
Setting the measuring volume: Press the "select" button to set the cursor position. To find
·
the measuring volume you want, press the "down" button and set to the correct value. Press
the "exit" button to exit the menu or press the "Menu" button to adjust the next parameter.
Setting the measurement time delay: Use the "up" and "down" keys to set the correct value for
·
the parameter. Press the "exit" button to exit the setting mode or press the "Menu" button to
adjust the next parameter.
Setting the place to store the measured values: Use the "up" and "down" keys to set the
·
correct value for the parameter. Press the "exit" button to exit the setting mode or press the
"Menu" button to adjust the next parameter.
Saving the reading settings: Use the "up" and "down" keys to confirm that you want to store
·
the measurements. Select with the arrow buttons "Yes" and confirm this with "Select."
·
Select Start, then select Saved Group, select Start again, Saved Group will flash, press Start
·
and Select group, then Start to begin measuring with new settings.
is now complete.
·
·
Main menu
Reset meter to factory settings
Delete collected date
Time setting
Save settings for measurement
Backlight
Save settings for measurement
The setup of the device
7
Set volume of measurement
Set delay time
Set place to save the readings
record
record
Advertisement
Table of Contents
