Table of Contents
Advertisement
6.5 Parameter setting
ND10 meters are configured with the use of LPCon
software available for free on the www.lumel.com.pl web site.
Fig 7. Setup menu.
Programming mode is enabled by pressing and holding
button for about 3 seconds. To enable the programming user
bust enter a correct access code. If there is not such a code,
the program transits into the programming option. Message SET
(in the first row) and first parameter group PAr are displayed.
user can view parameters at any time by pressing and holding
button for about 3 seconds.
1
Advertisement
Table of Contents
