Custom Programs; Auto Mode And Speed Settings - Blizzard Lighting Motif Atelier 16FX Manual

Custom Programs:

Allows users to create up to 3 customizable, 20 scene programs that are directly accessible via the control
panel and also in DMX mode.
Creating A Custom Program:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to PROG, and press <ENTER>.
2.) Now use the <UP/DOWN> buttons to highlight your choice of either CHS1, CHS2, or
CHS3 and press <ENTER>.
3.) Start with editing scene 1 (SC01), customizing it to your liking by using the choices outlined
in the table below. You can insert any of its 33 built-in auto programs (AT01-AT33), and adjust
its speed (ATSP 0-255), and also set the duration (in seconds) before moving on to the next
scene (TIME 0-255). Or, you can create a custom scene by color mixing any (or all) of the 3
pixel groups, then add in a fade in effect (WAIT 0-255), and/or strobe (SHUT 0-255). Finally,
if you want to use this scene in your program, be sure to enable it (USE: YES/NO).
4.) Repeat the above process to create up to 20 scenes in each of the 3 customizable programs.
R1 / R2 (0-255) - Red Intensity
G1 / G2 (0-255) - Green Intensity
B1 / B2 (0-255) - Blue Intensity
W1 / W2 (0-255) - WW Intensity
SHUT (0-255) - Strobe (slow - fast)
Running A Custom Program:
1.) To view your newly created lighting masterpiece, use the <MENU> and <UP/DOWN>
buttons to navigate to AUTO, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight your choice of either CHS1, CHS2, or CHS3 and
press <ENTER>. These are also directly accessible from the Effect Channel in DMX mode.

Auto Mode and Speed Settings:

Set single or Master/Slaved units to run automated programs at user selectable speeds.
Auto Mode:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to navigate to AUTO, and press
the <ENTER> button.
2.) Now use the <UP/DOWN> buttons to highlight any program ranging from AT01-AT33,
and press <ENTER>.
Auto Speed:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to AUTO and press <ENTER>,
then with the <UP/DOWN> buttons navigate to ATSP, and press the <ENTER> button.
2.) Make a selection from 0-255, and press <ENTER> to choose a speed (slow <--> fast).
Motif™ Atelier 16FX User Manual Rev. A
AUTO (AT01-AT05) - Auto Programs
ATSP (0-255) - Auto Speed (fast - slow)
TIME (0-255) - Scene Time (seconds)
WAIT (0-255) - Fade In (fast - slow)
USE (YES/NO) Use Scene in Program?
Page 13
IMPORTANT:
If USE is set to NO, or TIME is set
to 0, the scene will not run!
Copyright © 2018 Blizzard Lighting, LLC