Operating Adjustments; Dmx Mode & Dmx Mode Selection; Master/Slave Mode; Sound Active Mode - Blizzard Lighting Puck RGBAW Manual

4. OPERATING ADJUSTMENTS

NOTE: After making any change, the unit will return to the correct mode in about 10 seconds.
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fi xture is DMX, which appears as
Readout. Use the <ENTER> button then the <UP> and <DOWN> buttons to
choose a channel between
2.) To change between 3 and 6 channel DMX mode, select
<ENTER>. Select either
to confi rm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must
be the fi rst unit. Finally, chain the units together using DMX cable.
Master
3.) Select slave function by using the <UP>/<DOWN> keys to reach SLAV in
the Master/Auto menu on the slave units, and they will react in the same as the
Master.
Slave
NOTE: When a unit is set to slave and no master is connected,
appear on the LED display.
4.) On the master fi xture, use the <UP>/<DOWN> keys to reach SHND, which
allows you to select the Master/Slave mode.
Sound active
Auto mode
Color preset
Color strobe
To set a custom color in Master/Slave / Standalone Mode:
Using this function, you can select any color by adjusting the Red, Green, Blue, Amber and
White values from 0-255. You may also adjust the color balance of the fi xture.
Please note that modifying the values in this step will affect ALL modes, therefore
we recommend resetting all levels to their highest value (255) after using this
mode.
1.) Select
2.) Choose
confi rm.
3.) Using the <UP>/<DOWN> keys, select the color you wish to display by
varying Red/Green/Blue intensity between 0 and 255, then hit <ENTER> to
confi rm each color choice.
4.) Select Color preset mode as instructed above, then select
<ENTER> to confi rm.
The Puck RGBAW Manual Rev. B
1 512
and
3Ch, 5Ch
SLNd
then
SLNd
then
SoUn
then <ENTER> to confi rm.
CoLo
then
CoLo
then
StCo
then
then
NAnu
from the control panel, then hit <ENTER>.
rEd, GrEE bLuE, ANbE or Uhit
,
Page 9
Addr
. Press <ENTER> again to confi rm.
ChNd,
12Ch
or , then press <ENTER> again
NASt
to confi rm.
SLAu
to confi rm.
Auto,
then <ENTER> to confi rm.
CoL 1 - CoL 31,
0-255
(Slowest <-.-> Fastest)
CoL 1 - CoL 31,
, then hit <ENTER> to
CoL 15.
Copyright (c) 2011 Blizzard Lighting, LLC
on the LED
then press
Stby
will
<ENTER>
<ENTER>
then