Cursor Data - Furuno FAR-2218 Operator's Manual

1. OPERATIONAL OVERVIEW
Page 2
TARGET DATA / ACQ SETTING
TARGET CANCEL SETTING
1
* : Shown on A/B/W-types only
2
* : Shown on B/W-types only
3
* : Shown on A/B/W-types only when [5 AUTO TARGET TRACK], located in [2
MARKS] ([2 MARKS•CHARTS] for systems with Radar Plotter functionality)
TRACKS]
1.8

Cursor Data

The cursor data display shows the cursor's latitude and longitude position or the cur-
sor's X-Y co-ordinates.
Place the cursor on the [CURSOR DATA] box at the top-right side of the display then
press the left button to switch between display formats.
The data box shows the cursor location, bearing/range to the cursor location and the
time to go (TTG) to the cursor location.
Bearing/range
displayed
33°59.156'N
135°06.328'E
TTG
Note 1: For the X-Y co-ordinates display, the Y-axis is the upper/lower half of the
screen, the upper half of the screen is "plus" and the lower part of the screen is "mi-
nus". The X-axis is the left/right-side of the screen, right is "plus", left is "minus".
Note 2: Cursor data reads "- - -.-" when the cursor is placed outside the operational
display area.
1-14
Menu Item
[3 TARGET TRACK] menu, is set to [OFF].
Press the left button Press the left button
to switch between to switch between
display formats display formats
Cursor positon's
latitude/longitude
0.24.4ºR Bearing/range to
4.028NM
cursor position.
00:05 TTG to cursor position
Description
Change target tracking settings.
Change target cancel settings.
Cursor's X-Y
co-ordinates
displayed
33°59.156'N
135°06.328'E
X: +1.667NM
Y: +3.694NM
TTG
[7
X/Y axis
coordinates
to cursor
00:05
position.