Cursor Data Display - Furuno FAR-2107 Series Operator's Manual

10. Use the EBL offset feature to anchor the net cursor at net origin point.
1) Push the EBL OFFSET key.
2) Use the trackball to set net origin point.
3) Press the EBL OFFSET key to anchor the net cursor.
11. Steer the vessel so your ship's trail runs along the net cursor then throw the net.
2.3

Cursor Data Display

The cursor data box, which is located at the top right corner on the screen, can show
latitude and longitude position of the cursor, X- and Y-coordinates, and range and
bearing from your ship to the cursor. Further, if set and drift corrections are disabled,
two cursor data boxes may be shown, to display two sets of position information.
Left-click the cursor data box successively to change cursor data in the sequence
shown below.
36 23.693 N
+
Latitude and longitude
138 31.377 E
X-coordinate
(Starboard: plus, Port: minus)
0.280 NM
+
X-Y coordinate
0.374 NM
TTG to
Y-coordinate (bow)
cursor position
(Upward: plus, Downward: minus)
00:01
036.7 T Range and bearing from
+
own ship
0.466 NM
11