Table of Contents
Advertisement
1
Overview, Installation, and Selection of Probing Options
The E5402A-Pro Series Low-profile Right-angle 34-channel Single-ended Soft Touch Probe (for
analyzers with 90-pin cable connectors)
14
The Keysight E5402A-pro series probe is a 34-channel, single-ended, soft
touch probe compatible with the Keysight logic analysis modules listed in
Table 1
on page 12. It is capable of capturing data up to the rated
maximum state (synchronous) analysis clock rates of all the supported
analyzers, with signal amplitudes as small as 250 mV peak-to-peak. A
retention module must be installed on the target system board to attach
the probe to the board. There is a key on the retention module that
indicates the egress of the cable when the probe is attached.
A kit of five retention modules are supplied with each probe. Refer to
"Ordering retention modules"
more.
See
"Mechanical Considerations"
your target system board.
Figure 2
E5402A-pro series right-angle single-ended soft touch probe and E5412A
retention module
Keysight Technologies E5400-Pro Series Soft Touch Connectorless Probes User's Guide
on page 13 for information on ordering
on page 19 for information on designing
Advertisement
Table of Contents
