Virtual Mapping Function; (Dvs-V3232B/V6464B, Bkpf-R70 And Hds-V3232) - Sony BKS-R3202/R3210/R3220 Installation Manual

2-11. Virtual Mapping Function (DVS-V3232B/V6464B, BKPF-R70 and HDS-V3232)

2-11. Virtual Mapping Function

(DVS-V3232B/V6464B, BKPF-R70 and HDS-V3232)

Several routing switchers can be mapped on a virtual matrix with 512 inputs and 512 outputs in router
system. The matrix of one switcher can be also divided into several virtual levels and mapped.
For example, a switcher handling the 4:2:2 video signal and a switcher handling the 4 fsc video signal can
be mapped on the same level. By connecting them using a 4:2:2/4 fsc converter, the tie line control can be
performed (refer to Section 2-14).
DVS-A3232 has two modes such as 2-channel mode and 4-channel mode. Normally, either one will be
selected. However it is possible to use the overlapping area as the 4-channel mode by dividing the matrix
into two in the 2-channel mode and assigning them to the different virtual levels.
In the figure below, the 12 x 12 area where the level 2 and level 3 is overlapping is set to the 4 -channel
mode while the other is set to the 2-channel mode in the 20 x 20 area.
DVS-A3232
(2-channel mode)
32 20 12
It is called "Virtual mapping" that you assign crosspoints using the virtual matrices and virtual levels in
this way.
This virtual mapping function can be set in the menu item [L: SET PHYSICAL ASSIGNMENT] when a
DVS-V3232B/V6464B, BKPF-R70 or HDS-V3232 is used as the primary station.
n
When the matrix of a DVS-V3232B/V6464B is divided into two or more matrices on multiple virtual
levels, the monitor function for input/output signals may not work correctly.
2-6
Mapping to LEVEL-2 (1 to 20)
1
1
LEVEL-2
12
(AUDIO-1)
20
32
Mapping to LEVEL-3 (1 to 12)
LEVEL-3
(AUDIO-2)
20 12
1
1
12
20
: 2-channel mode
: 4-channel mode
12
1
1
12
ROUTING SWITCHER SYSTEM (E)