Default Values Initialization - Sony BKS-R3202/R3210/R3220 Installation Manual

5-7. Initialization of Table Data
HDS-V3232 :
Initializing Procedure
1 1. Set the test switch (S2) on the CPU-251 board to "D".
2. Press the reset switch (S8).
2 1. Set the test switch (S2) on the CPU-251 board to "C".
2. Press the reset switch (S8).
3 Select the menu item [K : RESET TO DEFAULT TABLE]
of the primary station and press [Y].
4 Select the menu item [K : reset To default table]
of the secondary station and press [Y].
5 Select the menu item [U : SELECT REMOTE PROTOCOL]
of the secondary station and press [F2] (DEFAULT).
n
The primary station of HDS-V3232 does not have the menu item[S].
The secondary station of the menu item [Z] of [SWITCHING FIELD] only.

5-7-2. Default Values Initialization

Item
Primary station [B : SET SOURCE/DEST TYPE]
[E : SET LEVEL TABLE]
[F : SET ACTIVE UNIT NUMBER]
[H : SET GLOBAL PHANTOM]
[J : NAME STYLE]
[L : SET PHYSICAL ASSIGNMENT]
[M : SET INHIBIT TABLE]
[N : SET DESCRIPTION NAME GROUP]
[O : SET TIE LINES]
[P : CHANGE PASSWORD]
[S : SELECT INDICATION COLOR]
[U : SELECT CONTROL MODE]
[V : SELECT WARNING DISPLAY]
[W : SYSTEM STATUS LOG]
[Z : SET UNIT DETECTABLE]
Secondary station [A : SET UNIT LOCATION ]
[U : SELECT REMOTE PROTOCOL]
[Z : SELECT SDI FORMAT]
Crosspoint data
5-56
Corresponding Menu Items
All items of the primary and secondary stations.
[W : SYSTEM STATUS LOG]
All items of the primary station excluding the
following 4 items.
. [H : SET GLOBAL PHANTOM]
. [N : SET DESCRIPTION NAME GROUP]
. [O : SET TIE LINES]
. [W : SYSTEM STATUS LOG]
All items of the secondary station excluding
the crosspoint data.
[U : SELECT REMOTE PROTOCOL]
Default Value
TYPE : 0=IN, 1=OUT, 2-F=None
NAME : IN001-IN512, OUT001-OUT512
All levels of all destination is ENABLE
Level name : 1, 2, 3....7, 8
DVS-V3232B : STATION 2-33 ENABLE
DVS-V6464B : STATION 2-65 ENABLE
Not set
Type + Num ("Type + Number" name mode)
Physical location number=Virtual location number
Not set
OFF
All channels : DIRECT
OFF
NO LOG
All STATION : OFF
No OFFSET
The input /output number is 1:1.
4:2:2, SWITCHING FIELD=FIELD
The input/output number is 1:1.
ROUTING SWITCHER SYSTEM (E)