3.3.1 Panel Mount
Panel mount mounting solutions is suitable for many applications where HMI should be embedded
in the machine. With this mounting solution flat surface leave no bezel in the front.
Size
7"
10.1"
15.6"
Installation Instruction
1. Prepare a fixture for the specific dimensions of the device.
2. Cut a hole on a sub frame or panel according to the cutout dimensions.
3. Install the device properly onto the cutout area of the sub frame or panel with the sides of the
front bezel.
4. Fix the device to fixture with eight Philips M3x4 screws.
Note:
Make sure that the eight holes on gasket can fit in the mounting
holes on the device.
Wall Cutout
249 x 157.6 mm
249 x 157.6 mm
360 x 292 mm
Chapter 3: Mounting
Screw Hole Diameter
M3 x 4mm
M3x4 mm
M3x5 mm
23