Sony RS-232C Interface Manual page 55

• Level (2-17th byte)
This command is used to set the ASSIGN level [dB].
LEVEL
-20 40[H] ('@')
-15 45[H] (' E')
-12 48[H] ('H')
-9 4B[H] ('K')
-6 4E[H] ('N')
-3 53[H] ('S')
0 59[H] Y') ('
• MIC1/WL1-MIC6/LINE2 ON/OFF (18th byte)
This command is used to turn ON/OFF the routing of the MIC1/WL1 to MIC6/LINE2 with the 8-bit data.
bit7 bit6
0 1
When you want to set the respective input channels to ON, set the corresponding bit to 1. When you want to set the corresponding bit
to 0.
Bit-6 and bit-7 are fixed all the time.
• LINE3-LINE4 A-C ON/OFF (19th byte)
This command is used to turn ON/OFF the routing of the LINE3 and LINE4 A to C with the 8-bit data.
bit7 bit6
0 1
When you want to set the respective input channels to ON, set the corresponding bit to 1. When you want to set the corresponding bit
to 0.
Bit-4 to bit-7 are fixed all the time.
• LINE4 D,E ON/OFF (20th byte)
This command is used to turn ON/OFF the routing of the LINE4 D and E with the 8-bit data.
bit7 bit6
0 1
When you want to set the respective input channels to ON, set the corresponding bit to 1. When you want to set the corresponding bit
to 0.
Bit-6 and bit-7 are fixed all the time.
Example: When setting the respective parameters of LINE OUTPUT1 as shown below.
MIC1/WL1-MIC5/LINE2 level
LINE3 L - LINE 4D-E SW level
MIC1/WL1-MIC6/LINE2 ON/OFF
LINE3 - LINE4A-C ON/OFF: LINE3
LINE4 D,E ON/OFF
43[H] 52[H] 4C[H] 31[H] 30[H] 59[H] 59[H] 59[H] 59[H] 59[H] 59[H] 4B[H] 4B[H] 4B[H]
4B[H] 4B[H] 4B[H] 4B[H] 4B[H] 4B[H] 4B[H] 4B[H] 4B[H] 4F[H] 40[H] 40[H] 0D[H]
( 'C R L 1 0 Y Y Y Y Y Y K K K K K K K K K K O @ @' )
bit5 bit4 bit3
MIC6/ MIC5/ MIC4
LINE2 LINE1
bit5 bit4 bit3
0 0 LINE4 A-C LINE4 A-C LINE3
R
bit5 bit4 bit3
LINE4 LINE4 LINE4
D,E D,E D,E
RS LS SW
: 0dB
: -9dB
: MIC1/WL1 through MIC4 are set to ON.
MIC5/LINE1 and MIC6/LINE2 are set to OFF.
: Set all to OFF.
: Set all to OFF.
bit2 bit1
MIC3 MIC2/
WL2
bit2 bit1
L R
bit2 bit1
LINE4 LINE4
D,E D,E
R C
– 55 –
bit0
MIC1/
WL1
bit0
LINE3
L
bit0
LINE4
D,E
L