Sony RS-232C Interface Manual page 11

PARALLEL OUTPUT ON: 43[H] 50[H] 4F[H] 4E[H] ('CPON')
This command is used to turn on OUTPUT of the REMOTE PARALLEL terminals separately of the SRP-X700P.
• Packet format
43[H] 50[H] 4F[H] 4E[H] "parameter" 0D[H]
• Parameter
Same as that of the PARALLEL OUT OFF command.
Example: When turning on channel 1
43[H] 50[H] 4F[H] 4E[H] 31[H] 0D[H] ('C P O N 1 CR')
PROJECTOR POWER CONTROL: 43[H] 50[H] 4A[H] 50[H] ('CPJP')
This command is used to turn on the power or to set the power standby of the projected that is connected to the PROJECTOR CONTROL
terminal of the SRP-X700P.
• Packet format
43[H] 50[H] 4A[H] 50[H] "parameter" 0D[H]
• Parameter
Specify either POWER ON or POWER STANDBY as the parameter.
POWER
STANDBY
ON
Example: When turning on the power of projector
43[H] 50[H] 4A[H] 50[H]41[H] 0D[H] ('C P J P A CR')
40[H] ( '@' )
41[H] ( 'A' )
– 11 –