Sony RS-232C Interface Manual page 51

REC OUT PARAMETER REQUEST : 52[H] 4F[H] 4D[H] 33[H],32[H] ('ROR1,2')
This command is used to read parameter of the desired single channel of the REC OUT 1 and 2 from the SRP-X700P.
The commands that correspond to the respective channels are shown below.
CHANNEL Command
REC OUT 1 52[H] 4F[H] 52[H] 31[H] 'ROR1'
REC OUT 2 52[H] 4F[H] 52[H] 32[H] 'ROR2'
• Packet format
52[H] 4F[H] 52[H] 31[H] "parameter" 0D[H]
(In the case of REC OUT 1)
• Parameter
Specify the scene No. of the scene memory that you want to read, as the parameter.
Method of specifying the scene No. is the same as that of the GROUP FADER command. See page 29.
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] ('A')) in the
order shown below.
41[H] "parameter" 0D[H]
The parameter is the same as the 9 bytes of the REC OUT1, 2 commands' parameter from which the scene No. is exempted.
REMOTE : 43[H] 53[H] 49[H] 4F[H] ('CSIO')
This command is used to set the CONTROL S OUTPUT and the PROJECTOR CONTROL.
• Packet format
43[H] 53[H] 49[H] 4F[H] "parameter" 0D[H]
• Parameter
The parameter consists of the 24 bytes all the time in the order as shown in the table below.
The 24th byte should always be set to the fixed value (30[H] ('0')).
byte
1st LINE3 MACHINE TYPE
2nd LINE3 CONNECTED CHANNEL
3rd LINE4A MACHINE TYPE
4th LINE4A CONNECTED CHANNEL
5th LINE4B MACHINE TYPE
6th LINE4B CONNECTED CHANNEL
7th LINE4C MACHINE TYPE
8th LINE4C CONNECTED CHANNEL
9th LINE4D MACHINE TYPE
10th LINE4D CONNECTED CHANNEL
11th LINE4E MACHINE TYPE
12th LINE4E CONNECTED CHANNEL
byte
13th LINE4F MACHINE TYPE
14th LINE4F CONNECTED CHANNEL
15th CONTROL S I/F TYPE
16th PJ CONTROL
17th LINE4 A SIGNAL DEFINE
18th LINE4 B SIGNAL DEFINE
19th LINE4 C SIGNAL DEFINE
20th LINE4 D SIGNAL DEFINE
21st LINE4 E SIGNAL DEFINE
22nd LINE4 F SIGNAL DEFINE
23rd PROJECTOR PROTOCOL
24th 30[H] ('0') fixed
– 51 –